EV charger installed at home — certified for Tesla Wall Connectors
Level 2 charging on a dedicated 240-volt circuit, sized for your car and your panel, anywhere in southwest Washington. I’m certified to install the Tesla Wall Connector, and I install ChargePoint, Emporia, and Wallbox chargers the same way — permitted, inspected, and warrantied for two years.
Free estimates on installs · $125 to diagnose, credited to the repair
Licensed, bonded, and insured · WA #TRUWOEL745MO
- Licensed · bonded · insured
- Two-year labor warranty
- Upfront pricing
- Evenings and weekends
What’s included
- Load calculation to confirm the panel has room for the charger
- Dedicated 240-volt circuit sized to the charger — 40, 50, or 60 amps
- Charger mounted and set up, hardwired or on a NEMA 14-50 outlet — your call
- Test charge with your car before leaving
- Permit pulled by Truworx — you don’t deal with L&I
- L&I inspection scheduled and passed, with the paperwork left with you
- Cleanup — packaging and old parts hauled off, floors vacuumed
- Two-year warranty on labor
What it costs
The charger itself is a small part of the price. Most of it is the circuit: how far the wire runs from the panel to where you park, and what it runs through. A panel in the garage next to your parking spot is the simplest case. A panel across the house, with wire through finished walls or a crawlspace, takes longer.
The other factor is your panel. If it has the space and the capacity, the install is quick. If it’s full or already close to its limit, the options are a smaller-amperage circuit, a load-management device, a subpanel, or a service upgrade — and each is a different number. You can supply the charger or have Truworx supply it.
Free estimates on installs. A photo of your panel with the door open and a photo of where the car parks is usually enough for a number by text.
How it goes
- Text me a photo of your panel with the door open and one of where the car parks. I’ll usually give you a number from that.
- Pick your charger, or have me supply one. I pull the permit.
- Install day is usually half a day. I text when I’m on my way, and you’re charging that night.
- L&I inspects, and you get the passed permit — you’ll want it for any utility rebate you apply for.
Good to know
Can my panel handle an EV charger?
Often yes, and I can tell from a photo. A Level 2 charger is usually a 40- to 60-amp circuit, and the question is whether your panel has both the physical space for the breaker and the capacity once your range, dryer, heat, and water heater are counted. That’s the load calculation. If it’s tight, a charger set to a lower amperage or a load-management device usually solves it without a service upgrade.
Hardwired or plug-in (NEMA 14-50)?
Both work. Hardwired is what the Tesla Wall Connector and most permanent chargers are designed for, it allows the full 48-amp charging rate, and there’s no outlet to wear out. A NEMA 14-50 outlet lets you unplug the charger and take it with you, but the circuit is limited to 40 amps of charging and the outlet needs a GFCI breaker under current code. If you’re staying put, I usually recommend hardwired.
How long does the install take?
Most installs are two to five hours. A panel in the garage near the parking spot is on the short end. Long wire runs, finished walls, or adding a subpanel push it toward a full day. You’ll know the plan before I show up.
Do I need a permit for an EV charger in Washington?
Yes. A new 240-volt circuit requires an L&I electrical permit and an inspection. I pull it and meet the inspector. Utility rebate programs generally require a permitted, inspected install, so the paperwork isn’t just a formality.
Are there rebates or utility incentives?
Sometimes, and they change. Clark Public Utilities and Cowlitz PUD have each offered EV charger incentives at different times, and there have been federal tax credits for home charging equipment. Check with your utility directly before you buy the charger, since some programs require you to apply first or to use a specific charger. I’ll make sure you have the permit and receipt they ask for.
Service area
Serving Brush Prairie, Vancouver, Battle Ground, Ridgefield, La Center, Kalama, Kelso, and Longview — Clark and Cowlitz counties, southwest Washington.
EV charger installation in Clark County — send me a photo of your panel and I’ll give you a number.
Free estimates on installs · $125 to diagnose, credited to the repair
Or text (509) 565-0103 — I’ll answer between jobs.
Licensed, bonded, and insured · WA #TRUWOEL745MO
